You are here: Edit Mode > Using Detail Tools > Blurring an Image

Blurring an Image

You can use the Blur tool to apply different kinds of blur to an image.

You can save your settings as a preset for future use.

To blur an image:

In Edit mode, in the Detail group, select Blur.
In the Blur type drop-down list, select the type of blur to apply.
Set the options as described below.
Do one of the following:
- Click Done to apply your changes and close the Blur tool.
- Click Cancel to discard all changes and close the tool.

Click Reset to clear your changes and reset to default settings. If you saved your changes, you cannot reset your settings.

Blur types

Gaussian	Produces an even, smooth blur.
Gaussian	Amount	Specifies the amount of blur. Move the slider to the right to intensify the effect.
Linear	Produces a blurring effect that gives the illusion of movement.
	Amount	Specifies the amount of blur. Move the slider to the right to intensify the effect.
	Angle	Specifies the direction of the blur effect.
Radial	Produces blur around a center point. Click the image to set the center point.
	Amount	Specifies the amount of blur. Move the slider to the right to intensify the effect.
	Clockwise	Specifies clockwise blur.
	Counter-clockwise	Specifies counter-clockwise blur.
	Horizontal position	Specifies the blur's center point on the horizontal axis.
	Vertical position	Specifies the blur's center point on the vertical axis.
Spread	Produces a smeared or frosted blur.
Spread	Amount	Specifies the amount of blur. Move the slider to the right to intensify the effect.
Zoom	Produces inward or outward blur to or from a center point.
	Amount	Specifies the amount of blur. Move the slider to the right to intensify the effect.
	Zoom in	Creates a blur that zooms in to the image's center.
	Zoom out	Creates a blur that zooms out from the image's center.
	Horizontal position	Specifies the blur's center point on the horizontal axis.
	Vertical position	Specifies the blur's center point on the vertical axis.
Smart Blur	Produces blur by detecting and avoiding edges, and preserves detail based on the threshold setting. This effect is usually used to smooth out skin.
	Amount	Specifies the amount of blur. Move the slider to the right to intensify the effect.
	Threshold	Specifies how little detail an area must have before the blur will apply to it.

You can right-click a slider to reset to the default value.

You can use the Edit Brush to paint this effect onto specific areas of your image.